At a regular, desktop level it can double or even quadruple a computer’s built-in WiFi signal. It will ignore networks in other directions. You can use the 10 dBi antenna (directional) to focus the reception in the direction that will give you optimal results. The maximum RF power output is 1000mW, which gives you a long-range WiFi signal. The amplifier is supplied in a dust and water-resistant case that has also been pre-treated to protect it from UV damage and corrosion. It has a WiFi amplifier (internal) that is combined with the high gain antenna (10 dbi), which is directional. Check that the power adapter is plugged in to a working power point and is switched on.This 2.4GHz extender will give a long-range power boost to the WiFi signal in RVs. No Light: No power source or the booster is not switched on.If the red light reappears, repeat steps 1–6 from the set-up process to pair the modem with the booster. Turn the power off at the wall, wait 30 seconds and turn it back on again to complete updates. This step may involve some trial and error until you find the right spot Simply move the booster closer to the modem until you get a solid blue light. The booster is too far away from the modem. You have a strong connection back to your Telstra Smart Modem If the purple start-up light does not change colour, turn the power off at the wall, wait 30 seconds and turn it back on to complete updates Wait 5 minutes for the light to turn solid blue. Purple: The software is updating, pairing or starting up.For the Telstra Smart Modem Gen 3, the password is the same as the Wi-Fi password found on the bottom of your modem. Or you can check the status of your connection by entering in your browser and signing in. The username is admin and the default password is Telstra for Telstra Smart Modem Gen 2 and 1.1. Once connected, the LED light should be a solid blue. The lights on your Telstra Smart Wi-Fi Booster can help keep you informed about the status of your Wi-Fi connection during set-up.
0 kommentar(er)
